iM3 CordEze
Proven to reduce hand fatigue by 60%.
Clinically proven to Eliminate cord pullback forces.
Improves Ergonomics, Efficiency &Infection prevention.
- Includes: one wristband and two adapters
- Fits 4 - 12 mm diameter cords
- Sterilize or disinfect
- Adjustable sizing for the wrist/arm
- Made in USA
INSTRUCTIONS
Wrap iM3 CordEze band around your wrist, inserting the pin through the loop. Pull tight and snap metal pin into desired hole to secure. Insert cord by sliding. Start from either end of the slot.
Hold cord between index finger and thumb. Press down while sliding the cord through the slot until cord is under the top flaps. Slot can be worn on top or bottom of wrist/arm.
You can now operate the handpiece without holding the cord. To remove cord, lift up near slot.
Determine the amount of cord slack needed and slide the adapter onto the cord. (Optional - Place non-stick protective barrier tape on the cord and place adapter on the cord over the tape).
TO USE: Hold the handpiece with a working grip in your dominant hand. Hold the adapter between your finger and thumb and slide the adapter into the iM3 CordEze slot. (Helpful Hint - Squeeze the bottom portion of the adapter to widen the slot). You can now operate the handpiece without holding the cord.
TO DETACH: Hold the adapter and slide it out if the iM3 CordEze wristband, keeping it attached to the cord. (Keep the adapter attached to the cord).
INFECTION CONTROL: Sterilize in autoclave, bagged and unpinned or disinfect using double wipe method with an intermediate-level disinfectant.